22
E-flite Habu 32 EDF ARF Assembly Manual
9. Secure a 3-inch (76mm) servo extension to the
lead on the retract mechanism using string or a
commercially available connector.
10. Tie the end of the string around the end of
the extension. Use care not to pull the string
from the wing.
11. Use the string to pull the lead through the wing
and out at the root rib as shown. Remove the string
once the lead has been pulled through.
12. Place the correct retract assembly in position.
The axle will face to the root of the wing, and the
spring will face to the trailing edge of the wing. Use
four 3mm x 14mm countersunk self-tapping screws
and a #1 Phillips screwdriver to tighten the screws.
14. Select the correct adapter that fits to the
landing gear strut. Insert two adapters in either side
of the hub of the wheel.
15. With the flap lowered, rest a square against
the flap hinge line. Look down on the axle and
check that it is perpendicular to the square as
shown. If not, it may be necessary to lightly file the
flat areas on the landing gear wire to correct for
any misalignment.
