28
E-flite F-86 Sabre 15 DF ARF Assembly Manual
Note
: When flying your model in locations
where the air temperature is very high, you will
need to mount the ESC between the wing rods.
Cut a hole in the bottom of the fuselage so the
fins of the ESC can be exposed to the air flow
outside of the fuselage. This keeps the ESC cool
and prevents over-heating.
High-Temperature ESC Location
Cut hole for ESC cooling
3. Insert the leads from the speed control through
the hole in the former in the fuselage as shown.
4. Use a small amount of hook and loop tape to
mount the switch from the speed control to the side
of the fuselage. Make sure to position it where it
can be easily accessed.
5. Cut two pieces of hook and loop tape and apply
it to the bottom of the main and remote receivers as
shown. Leave the adhesive backing on the mating
hook and loop until instructed to do so.
4. Plug the leads from the aileron servos, elevator
servo, steering servo and speed control into the
appropriate ports of the receiver. Use hook and
loop tape to attach the receiver inside the fuselage
as shown in the photo.
