19
E-flite F-86 Sabre 15 DF ARF Assembly Manual
2. Remove the arm from the servo. Use side cutters
to remove any arms that will not be used.
3. Use a pin vise and 5/64-inch (2mm) drill bit to
enlarge the hole in the servo arm.
4. Insert the pushrod connector in the hole. It
should move freely in the hole but not have
excessive slop.
5. Slide a 2mm washer on the threaded end of the
pushrod connector.
Always use threadlock on metal-to-metal fasteners
to prevent them from vibrating loose.
6. Install the 2mm nut on the pushrod connector.
Don’t over-tighten the nut causing the pushrod
connector not to move. The nut should be just tight
enough, so the connector can rotate freely. Make
sure to secure this nut with threadlock or CA.
7. Install the servo horn on the servo using the screw
provided with the servo and a #1 Phillips screwdriver.
8. Install the servo grommets and brass eyelets
in the servo.
