29
E-flite F-15 Eagle ARF Assembly Manual
Receiver Installation
Required Parts
Assembled airframe
18-inch (457mm) lightweight servo extension (2) (aileron)
12-inch (305mm) lightweight servo extension (2) (main retract)
Y-harness (2) (3 if retracts are installed)
Required Tools and Adhesives
Clear tape
Hook and loop tape
String
1. Secure an 18-inch (457mm) lightweight servo
extension to each of the aileron servos. If retracts
have been installed, secure 12-inch (305mm)
extensions to each of the retract servos. Use clear
tape to tape the leads and extensions inside the intake.
You may use string to pull the extensions through the
center of the model.
2. Secure the receiver on the top side of the same
plywood plate the nose gear is attached to, using hook
and loop tape. Plug the servo leads for the elevators,
ailerons, retracts, nose gear steering and speed controls
into the receiver. Use a Y-harness between each of the
speed controls, between the aileron servo extensions and
one of the main and nose gear retracts.
3. Use clear tape to secure the servo leads neatly
inside the battery compartment. Doing so will make the
installation and removal of the batteries much easier.
