this tone sounds, no more access attempts are made until the push-to-talk switch is released and then pressed
again.
•
If this tone sounds after the transmitter has been on for an extended period and “TX TIME” also appears in the
display, the transmitter has been disabled by the time-out timer feature (see “Time-Out Timer”).
•
If this tone sounds as soon as the push-to-talk switch is pressed and “TX DSBL” appears in the display, a channel
is selected in the conventional mode that is programmed as receive-only (see “Receive-Only Channels”).
Clear-To-Talk Tone
This is a short tone which sounds when the push-to-talk switch is pressed. It indicates that the system has been
successfully accessed and speaking can begin (see “Clear-To-Talk Tone”).
Key Press Tone
This is a short tone that sounds when a key is pressed. This tone can be enabled and disabled using the menu
selected by turning power on with the Auxiliary key on the side pressed (see “Key Press Tone Disable”).
NOTE: The following tones are heard only when making telephone calls.
Confirmation Tone
This is a short tone that sounds when the number just dialed is accepted by the system.
Call Proceed Tone
With some non-telephone special calls, ringing does not occur after the number is dialed. Instead, another short
tone sounds after the confirmation tone to indicate that the audio path is complete and speaking can begin.
End Call Tone
Three beeps which indicate that the end of the call has been detected by the system.
Proceed Dialing Tone
When placing a landside to a mobile (refer to “Landside Originate Calls”), the landside caller may dial the system
and then enter a special number which specifies the mobile being called. This tone sounds when the system answers to
indicate that this special number should be dialed (see “Landside-Originate Calls”).
MULTI-NET AND CONVENTIONAL MODES
General
This transceiver can be programmed to operate in both the Multi-Net and conventional modes. Each selectable
system can be programmed for either type of operation. You can probably assume that Multi-Net operation has been
programmed unless your system operator tells you otherwise. The type of operation programmed is determined by the
type of radio equipment in use. There are only a few differences in operation, and they are described in the following
information and also elsewhere in this manual as required.
