bers can be locked so that they cannot be changed. If you were to change a number with a unique identification,
the identification is erased and it can be reprogrammed again only by taking the transceiver back to your system
operator.
Terminating a Call
When a conversation is finished, the call should be terminated by transmitting the # character. This is done auto-
matically when the phone mode is exited by pressing the PHON key or it can be done manually by pressing the #
key. Three beeps sound to indicate that the system has detected the end of the call. Terminating the call in this
manner prevents additional billing that may occur for the time it takes the system to automatically detect the end of
a call.
QUICK SELECT SWITCH
General
The rotary quick select switch on the top panel can be used to select up to sixteen preprogrammed system/group
combinations. These positions can be programmed as described in the next section or they can be programmed by your
system operator. If a position has not been programmed, the selected system/group does not change. The dot (
•
) posi-
tion is a selectable position the same as positions 1-15. Your system operator may install stops that limit the rotation of
the quick select switch to the positions that are programmed. For example, the switch may rotate only to positions 1-6.
When a position is programmed by your system operator, it can be locked so that it cannot be reprogrammed.
When a locked position is selected, “QLK” is displayed and the front panel S (System) and G (Group) select keys are
disabled. This ensures that the system/group programmed for that position is always selected. This is especially useful if
the display cannot be viewed, such as when carrying the transceiver on a belt.
Programming a Switch Position
Programming a Switch Position
Switch positions can be programmed with any selectable system/group unless they are locked by system operator
programming as described in the preceding section. Proceed as follows to program a position:
1. Set the quick select switch to the position to be programmed.
2. Select the system/group for that position by pressing the front panel S (System) and G (Group) keys. If “QLK”
is displayed and these keys are disabled, the switch position is locked and cannot be reprogrammed.
3. Press the 2ND (RTN) key and then the QSTO (SCN) key. If “LOCKED” is displayed and a beep sounds when
the QSTO key is pressed, this also indicates that the switch position is locked and cannot be reprogrammed.
SYSTEM SCAN
General
NOTE: In some cases, such as if your transceiver is programmed with only one system or if calls are received on
only one system, you may choose not to use the system scan feature.
