SMARTNET/SMARTZONE FEATURES
35
3. Press the PTT switch to initiate the call. The display then indicates the
alias of the destination radio. Proceed to the bulleted list following the
next method for conditions that may occur next.
Direct Entry (With Microphone Keypad Only)
1. With a SMARTNET/SmartZone channel selected, press and hold the
Private Call option switch until a tone sounds (approximately 1
second). The private call mode is indicated by “
C
” in the upper part of
the display, and the last ID called is displayed on the upper line.
2. Using the 0-9,
#
, and
keys, enter the 6-digit ID of the mobile unit
you are calling. To erase the last digit entered, rotate the Select switch
counterclockwise, and to cancel the call, press the Private Call switch.
3. Press the PTT switch to initiate the call. If the entered ID is invalid,
“INVALID” is momentarily displayed and the call is not initiated. If the
entered ID is valid, the alias of the ID is displayed on the lower line if
it matches an ID in your call list. Otherwise, only the ID you entered
continues to be displayed. Conditions that may then occur are as
follows.
•
If the radio you are calling is on the air, telephone type “ringing” is
heard for 20 seconds or until the called party answers.
•
If the called party answers and the call is successful, the person’s
voice is heard and the call is carried on the same as a group call. To
end the call at any time, press the Private Call switch.
•
If the called party does not answer within 20 seconds, “NO ANSWR”
is displayed and a continuous tone sounds. End the call by pressing
the Private Call switch.
•
If the called radio is not in service, no ringing is heard, “NO ACK” is
displayed, and a continuous tone sounds. End the call by pressing the
Private Call switch.
*
