E+E Elektronik EE75, User Manual

Page: 9 / 24

8
Hardware
5. Operating Components
5.1 Circuit Board
5.2 Jumpers for Setting the Output Signal
If the sensor output signal is set from current to voltage by use of the configuration
software, additionally 2 jumpers must be set on the circuit board as follows:
EE75-TxA6
(for current output, e.g. 4 - 20 mA)
EE75-TxA3
(for voltage output, e.g. 0 - 10 V)
5.3 Jumpers for Setting the Velocity Response Time
The EE75 allows users to set the velocity response time:
a) Setting the velocity response time using jumpers:
Jumper position
(Also see chapter 5.1 - Circuit Board)
: Response time:
No jumper 1.5 s
Jumper at pos. 1 2 s (factory setting)
Jumper at pos. 2 4 s (factory setting)
Jumper at pos. 3 10 s (factory setting)
b) Setting the velocity response time using configuration software:
The response time ( τ
90
) can also be set to any value between 1.5 and 40 s using the
configuration software, without changing the jumpers on the circuit board.
See Configuration Software, chapter 4.4 - Response Time
Jumper# Function
I Current output signal
S Signal
U Voltage output signal
1 (arrow) τ
90-
1
-velocity (2s)
2 τ
90-
2
-velocity (4s)
3 τ
90-
3
-velocity (10s)
4 Free
5 Free
Jumper
(detail A)
Detail A:
Plug connection
blue
I S U
I S U