3. Slide the shim onto the handlebar. Install the
handlebar grip so the grip end is flush with the
handlebar end.
4. Slide the shifter body against the grip shim.
5. Rotate the shifter body so the adjusting bar-
rel is below the brake lever. Tighten the shifter
clamp bolt to the specification in Table 4.
6. Check the operation of the brake lever.
Reposition the shifter body as necessary.
7. Secure the shift cable to the front brake
cable with the S-hook (Figure 1). Be sure the
rear brake cable is positioned behind the S-
hook.
8. Fit the mirror housing into the handlebar end
(Figure 2). Tighten the mirror mounting screw
to the specification in Table 4.
SHIFTER CABLE
Removal
NOTE
Before removing the shifter cable, note how
the cable is routed along the frame. The new
cable will have to be routed along the same
path.
1. Operate the shifter and move the chain to
the outermost cog.
2. Remove the right side cover from the E-Bike
®
.
3. Note how the shifter cable is routed along
the top tube and the right seat stay. The cable
will have to be rerouted along the same path.
4. At the derailleur, remove the end cap (A,
Figure 4) from the end of the inner wire.
5. Loosen the pinch-mechanism nut (B, Figure
4). Pull the shifter cable from the derailleur
pinch mechanism and out of the barrel
adjuster.
6. Slide the lower cable housing (C, Figure 4)
off the inner wire. Do not lose the ferrule from
either end of the lower cable housing.
7. Release the inner wire from the two housing
stops on the right seat stay (A, Figure 5).
8. Slide the tube (B, Figure 5) that sits
between the two housing stops off the inner
wire.
9. Pull the shifter cable from the cable inlet in
the right side cover.
10. Slide the upper cable housing from the
inner wire (Figure 6). Do not lose the ferrule
from either end of the upper cable housing.
FIG. 4
FIG. 5
FIG. 6
FIG. 7
Chapter Six
6-2
B
A
C
A
B
