Step 4:
Press the P button to save. LED 4 flashes. See further 7.4.
The end position for "Open" is now stored.
7.4Setting the end position "Closed"
Step 1:
LED 4 flashes, now press the button "-", to close the door. When the garage door is
fully closed, release the button "-". If the door is closed too far, briefly press the "+" button to
move the door upwards slightly. With the buttons "-" "+" you can correct the situation further.
Step 2:
Press the P button to save. Now the drive will open the door with a test run 1 x
open and close. Then LED 3 will light up.
The end position for "Closed" is now stored.
Note:
Adjusting the end positions can be repeated whenever necessary.
7.5Adjustment of the force for opening and closing.
Note:
The force limiter is set at the factory (Open step 4, Close step 3) and rarely requires
adjustments. Use the following steps to adjust the force limiter. The highest level is 8 for both
directions.
7.5.1Setting the force for opening
Step 1:
Press the button "P". LED2 now flashing.
26
