Installation Instructions:
(performed by purchaser
–
requires approximately 10 minutes)
It is recommended to view the video of installation, which is available at:
https://youtu.be/CJjecnSawdo
STEP 1: Accessing Shift Lever Connector
It is recommended to disconnect the negative battery terminal prior to completing this
installation.
Center-console cover must be loosened to allow access to the shift-lever electrical connector.
With
VEHICLE IN PARK
, remove shifter knob. Slide the locking-ring of the shift-knob downward,
then unscrew the shift knob from the post by turning counterclockwise.
Pull parking brake up slightly and open the lid of the center console storage compartment.
Grasp the center console on both sides near the forward cup-holders. Pull straight-upward to
unclip the plastic cover from the underlying tunnel. Then grasp the center console near the rear
cup-holder on both sides and firmly pull upward to unclip the back portion.
Grasp the center console on each side near the forward cup-holders. Firmly and quickly pull
straight-upward to un-clip the plastic cover from the underlying tunnel. There are no screws to
remove. DO NOT PRY on any portion of it, as it is not necessary. Similarly, grasp the center
console near the aft cup-holder on both sides and firmly pull upward. This back portion will unclip
as well.
