service manual
Issued 05/05
26
Fitting notes
Refitting the motor bucket and ball
Dress the looms neatly in the side of the
duct and fix in place with 3 cable ties.
IIm
mp
po
orrtta
an
ntt:: ensure the upright switch loom is
located under the screw boss.
Lower one half of the ball assembly onto
the large and small bearings. Repeat for the
other side. Snap together and refit the four
screws.
Place the wires from the motor bucket
seal/loom assembly through the large hole in the
side of the duct. Locate the motor bucket axle
into the hole in the valve assembly.
Align the screw bosses on the rear of the
motor bucket seal/loom assembly with the
locators in the base of the duct.
Push the rear of the motor bucket into the
side of the duct. Refit the two screws.
111
112
110
113
109
