P/N: 975389
|
Rev: current
|
ECO: xxxxx
www.dynisco.com
From lab to production,
providing a window into the process
-14-
4
Assembly
4.1
Assemble IRCU-STAND (optional)
If the optional IRCU-STAND has been purchased, the locations for mounting the RSU, RCU,
and HMI have been predetermined. Assemble the stand per the instructions below. If this
stand was not purchased, skip to section 3.2.
NOTE: Item numbers refer the numbers on drawing IRCU-STAND (included at the end of
this section), unless noted.
4.1.1
Assemble Base
•
Loosen the four connector set screws on the cross brace extrusion (item 13 - QTY 1)
•
On each end of item 13, slide one caster extrusion (item 2 - QTY 2) onto the T nuts
•
The two T nuts on each end of item 13 slide into one slot of item 2.
•
Center and position each item 2 perpendicular to item 13
•
