Dynisco IPX II Series, Operating Manual

Page: 49 / 78

49
COMMISSIONING
the NEXT NEXT
NEXT NEXT
NEXT key to move onto the next function. If a change is required, press the ENTER ENTER
ENTER ENTER
ENTER key to go into the
list of temperature units. Use the NEXT
NEXT
NEXT NEXT NEXT key to sequence through the selectable temperature units. One
can stop at any one of the temperature selections by pressing the ENTER ENTER ENTER ENTER ENTER key. This changes the IPX II
Series Smart Pressure Transmitter mode to the required temperature units. The list of temperature units is
listed below:
(Degrees Celcius)
Press the NEXT NEXT
NEXT NEXT
NEXT key to go to the next unit (continue to do this until the desired temperature unit is
listed and then press ENTER
ENTER
ENTER ENTER ENTER).
(Degrees Fahrenheit)
(Degrees Rankin)
(Degrees Kelvin)
After pressing ENTER
ENTER
ENTER ENTER ENTER to select the desired temperature units the display returns to:
Press the NEXT
NEXT
NEXT NEXT NEXT key to move onto the next function.
7.2.2 7.2.2
7.2.2 7.2.2 7.2.2
F FF
FF
S S
S S S
ENSOR ENSOR
ENSOR ENSOR
ENSOR
P P
P P P
O O
O O
OSITION SITION
SITION SITION
SITION
A A
A A A
DJUS DJUS
DJUS DJUS
DJUSTMENT TMENT
TMENT TMENT
TMENT
The next function of the IPX II Series Smart Pressure Transmitter will adjust the actual installed sensor
position. Any “shift” caused by elevation will be removed using this adjustment.
Failure to apply sensor position adjustment may cause inaccuracy in the pressure
measurement.