11
Full Motion Mount for TVs 47" - 70"
DX-HTVMM1703-C
STEP 5 -
Option 2: Installing on a solid concrete or concrete block wall
CAUTION:
To prevent property damage or personal injury, never drill into the mortar between blocks. Mount the wall plate directly onto the
concrete surface.
1
Align the center of the wall plate template at the height (
a + b
) you determined in the previous step, make sure that it is level, then tape it to the
wall.
2
Drill four pilot holes through the template to a depth of 2.4 in. (60 mm) using a 3/8 in. (10 mm) diameter masonry drill bit, then remove the
template.
3
Insert the concrete wall anchors (
B2
) into the pilot holes and use a hammer to make sure that the anchors are flush with the concrete surface.
4
Align the wall plate on the wall mount with the anchors, insert the lag bolts (
B1
) through the lag bolt washers (
B3
), then through the holes in the
wall plate. Make sure that the wall plate is level. Tighten the lag bolts with a socket wrench only until they are firm against the wall plate.
CAUTION:
DO NOT over-tighten the lag bolts (
B1
).
.
You’ll need
2.4 in. (60 mm)
* Minimum solid concrete thickness: 8 in. (203mm)
* Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
* Minimum horizontal spacing between fasteners cannot be less than 16 in. (406 mm).
Align the
center of the
template with
the height
mark (
a+b
) you
made in STEP 4.
3/8 in. (10 mm)
Concrete
wall
B2
B3
B1
Magnetic removable
bubble level
Edge-to-edge
stud finder
Drill
3/8 in.
masonry
drill bit
Wall plate template
Tape
B2
(4)
Hammer
B1
(4)
B3
(4)
Socket
wrench
Wall mount
Magnetic
removable
bubble level
DX-HTVMM1703-C_16-0713_MAN_V2_ENG.fm Page 11 Thursday, October 6, 2016 10:47 AM