10
Full Motion Mount for TVs 47" - 70"
DX-HTVMM1703-C
STEP 5 -
Option 1: Installing on a wood stud* wall
Note
: Any drywall covering the wall must not exceed 5/8 in. (16 mm).
1
Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2
Align the center of the wall plate template at the height (
a + b
) you determined in the previous step, make sure that the template is level, then tape
it to the wall.
3
Drill four pilot holes through the template to a depth of 2.4 in. (60 mm) using a 3/16 in. (5 mm) diameter drill bit, then remove the template.
4
Align the wall plate on the wall mount with the pilot holes, insert the lag bolts (
B1
) through the lag bolt washers (
B3
), then through the holes in the
wall plate. Make sure that the wall plate is level. Tighten the lag bolts with a socket wrench only until they are firm against the wall plate.
CAUTION:
DO NOT over-tighten the lag bolts (
B1
).
You’ll need
* Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm).
* Minimum horizontal spacing between fasteners cannot be less than 16 in. (406 mm).
Align the center of the
template with the
height mark (
a+b
) you
made in STEP 4.
2.4 in. (60 mm)
3/16 in. (5 mm)
B3
B1
Stud
finder
Wood
stud
Magnetic removable
bubble level
Edge-to
edge stud
finder
Drill
3/16 in.
wood drill
bit
Magnetic removable
bubble level
Wall plate template
Tape
B1
(4)
B3
(4)
Wall mount
Socket
wrench
DX-HTVMM1703-C_16-0713_MAN_V2_ENG.fm Page 10 Thursday, October 6, 2016 10:47 AM