Dyness DYN-B4850 Setup Download Page 2

Page: 2 / 5

Step 2 : Dial DIP switch on master

Make sure host battery DIP is 0010,slaves 0000

Step 3 : Cable connect in battery

Keep batteries off, connect power cable

、

parallel cable

、

communication cable Bat-Inv and comm cable Bat-Bat as above.

Comm cable from the host CAN IN port to the inverter CAN port

Comm cable from the host CAN OUT to slave1 CAN IN,slave1
CAN OUT to slave2 CAN IN….

Power cable should be connected diagonally ,one is connected
at the top socket and another one is at the bottom.

Summary of Contents for DYN-B4850

Page 2: ...er cable parallel cable communication cable Bat Inv and comm cable Bat Bat as above 1 Comm cable from the host CAN IN port to the inverter CAN port 2 Comm cable from the host CAN OUT to slave1 CAN IN slave1 CAN OUT to slave2 CAN IN 3 Power cable should be connected diagonally one is connected at the top socket and another one is at the bottom ...

Page 3: ...er or Fuse between inverter and battery to protect both products Step 5 Switch on all the B4850 power switch then press the host SW button about 3S to wake up it all the slaves will be woken up automatically Step 6 Turn on the DC breaker Step 7 Power on the inverter ...

Page 4: ...inverter are connected Now inverter is started it should show the battery voltage battery and inverter are connected Step 11 Inverter setup Long press ENTER to set make sure 05 are properly set as below 05 LI type Lithium ...

Page 5: ...go Step 13 Shut Down 1 Remove all the load 2 Disconnect PV Grid 3 Turn off DC breaker between the battery and inverter 4 Turn off the inverter power switch shut down the inverter 5 Long press SW button to power off the battery then switch off all the batteries Power switch ...