21
Dynaset Oy | Menotie 3, 33470 Ylöjärvi | puh. 03 3488 200 | [email protected] | www.dynaset.com
HYDRAULIC MAGNETS
INSTALLATION
4. INSTALLATION OF THE HMAG PRO
4.1. INSTALLATION TO A HYDRAULIC TOOL LINE
The HMAG PRO is recommended to be installed into the base machine’s existing
hydraulic tool line. Usually other installations are not required and the HMAG PRO
can be operated from the existing controls.
Install the hydraulic tool lines
pressure (P)
and
return (T)
to their correct places
on the HMAG PRO.
Ensure that the hydraulic flow of the base machine is sufficient to run the unit.
At least the minimal flow must be available. READ CHAPTER ”10. TECHNICAL
SPECIFICATIONS” for more information.
Picture 9: Couplers of the HMAG PRO
ATTENTION!
Ensure that the filtering degree and cooling capacity of the hydraulic
system are sufficient. READ CHAPTER ”10. TECHNICAL SPECIFICATIONS” for
