Dynapac CC1250, Instruction Manual

Page: 47 / 74

3. Tighten the nut against the brake tool until it
stops, indicating that the brakes is now
disengaged.
Engaging the Brakes
1. Screw out the nut again after towing.
41 Inspections and Operations
Figure 6-11: Left Side of Drum
A Brake tool C Disengagement nut
B Fastening screw
Note
Make sure to secure the steering wheel
to maintain a straight-ahead position.
4. Slightly tap the plunger inside using a mallet.
Figure 6-12: Plunger
A Pluger
2. Screw off the brake tool and fit it back into its
fixing holes
3. When machine is started, propulsion pump
plunger will automatically come out.
4. Refit the center plug to counteract the
information of rust inside the threaded hole.
5. When towing/retrieving a machine, the towing
device must be connected to both lifting holes.
The pulling force shall act longitudinally on the
machine. Maximum total pulling force 130 kN
(29225 lbf).
Figure 6-13:Towing