24 CA 251 M251-1EN1
EVERY 1000 HOURS OF OPERATION (EVERY SIX MONTHS)
1
Fig. 46 Planetary gearing/filling position
1. Plug
Place the roller on a level surface with the plug (1) at its
lowest position.
Unscrew this plug and drain the oil into a suitable
receptacle. The volume is about 2 litre (4.23 qts). Place
the roller on a level surface with the plug (1) at its
lowest position.
Rear axle planetary gearing
– Oil change
Fig. 45 Planetary gearing /draining position
1. Plug
1
Run the roller so that the plug is at 9 o’clock.
Fill oil through the plug to the lower edge of the hole.
Screw in the plug and repeat the procedure on the
other side. Use transmission oil. See lubricant
specification on page 3.
Summary of Contents for CA 251
Page 2: ......
