Install Video at
www.DynamicMounting.com/Install
11
Wi-Fi (IP) Controls
These Instructions are for the Wi-Fi (IP) controlled mount, NOT the IR and RF controlled mount, see page for that information.
Pinching and Crushing Hazard:
The wall mount actuation is very strong, do NOT
run the mount when anyone is near the mount. Do NOT have any part of the body in the mount
or between the TV and Wall. The Mount will keep driving until someone pushes another button
on the remote to stop it. When working on the mount unplug the power.
IR Remote Control
The IR remote comes with a battery and needs to be pointed at the IR receiver to work. It will work out of the box.
IR Remote and Website Buttons
– Move the mount up to the topmost set position
o
Mount cannot be driven higher then set limit
o
Comes set for max top position
o
Hold to drive to position
– Move the mount down to the bottom most set position
o
Mount cannot be driven lower then set limit
o
Comes set for lowest bottom position
o
Hold to drive to position
1
– Move the mount to the set 1 position
o
Mount will drive to this position from either direction
o
Does not come set out of the box
o
Hold to drive to position
2
– Move the mount to the set 2 position
o
Mount will drive to this position from either direction
o
Does not come set out of the box
o
Hold to drive to position
Run
(IR) – Automatically move to the position selected
o
Press Run then any position button within 3 seconds and
the mount will move there automatically
o
Press any button to stop movement
Set
(IR) - Set and Clear All Positions
o
Press Set, then Hold position button for 3 seconds (light
will flash green once) to set the current position for that
button, light will flash white twice when let go to
indicate the position is set.
o
Press Set, then Hold position button for 6 seconds (light
will flash green twice) to clear the position for that
button, light will flash red then white when let go to
indicate the position is cleared.
Set
(IR) - Only Set Positions 1 and 2
o
Press Set, then position button 1 or 2. Light will flash
white twice when let go to indicate the position is set.
o
To set the Top or Bottom positions, or to clear any
positions, you’ll need the IR remote.
Stop
(IP) – Press this or any button to stop movement
Note:
On IR press each button firmly; a quick tap will
probably not work.
AutoMove is Dangerous:
The Mount will keep driving until someone pushes another
button on the remote to stop it or it reaches the position. Keep an eye on the mount until it stops
moving. The wall mount actuation is very strong. Do NOT run the mount when anyone is near
the mount. Do NOT have any part of the body in the mount or between the TV and Wall.
Automatically Move to Position
The mount can be automatically moved to any set position without having to hold the button. On the website it does this
automatically. On the IR remote, press
Run
and then the Position Button (
,
,
1
,
2
). To stop movement, simply push any button on
the remote.
Preventing Mount from Hitting Shelf
If the mount would hit the shelf or some other object in the top or bottom position. You can easily reduce the top (
) and bottom most
(
) position so that the mount cannot move past that point. Follow the directions in the
Remote Control Buttons section above.
Overheat Detector
The IR receiver also has a temperature sensor built into it. If it detects a temperature greater than 50 degree C (122 F), the mount will
move up. We recommend attaching the sensor to the TV to make use of this feature.
Note:
For additional information about the IP controller and how to connect to other systems go to
