Dynamic CCTV DTV-VLDpro-W6, User Manual

Page: 31 / 40

29 29
Vandal Resistant Dome Camera
● MOTION DET : Commands the camera to motion-detect and trace an object.
1. If the SPECIAL menu screen is displayed,
use the Function Setup switch so that the
arrow indicates ‘MOTION DET’.
2. Set it to ‘ON’ by using the Function Setup switch.
• When using AC power at 60Hz(NTSC), 50Hz(PAL) frequency, you can use the LL type
synchronization.(Do not Input AC to DC Type camera)
• When the power is DC 12V, the SYNC menu is fixed to the ‘INT’ mode.
- DETECT BOX : Outlines an object on the screen in a box when its movement matches a custom
Motion Type.
- ALARM OUT : Releases a signal from the MD Output Terminal of the camera when an object’s
movement matches a custom Motion Type.
- DETECT AREA : Defines the Motion Detection area.
- MASK AREA : Specify a detection exception area to mask.
Select a mask area number and specify the
size and position.
► AREA : You can select up to 4 areas.
► MODE : Determines whether to use the area selected
in the AREA.
► TOP / BOTTOM / LEFT / RIGHT :
Adjust the size and position of the selected area.
► RETURN : Select this to save the MASK AREA menu
settings and return to the
INTELLIGENCE menu.
· SENSITIVITY : Set the sensitivity of the motion detection.
When adjusting the sensitivity, note that the
lower the level means the higher sensitivity.