Dynalink RTA1320, User Manual, Page: 99 / 137

Chapter 4: Web Configuration
The WAN IP settings page will differ
slightly according to the protocol t
you choose. The graphic is the one
that you will see if you choose the
PPPoE mode in the
hat
previous step.
te.
You can select Enable NAT or change
the MTU value according to your
needs.
Add Default Route:
Check this item to add a default rou
The next figure following the WAN IP
Settings in the PPPoE mode is sho
at the right. Y
wn
ou may refer to the
Quick Setup for further information.
If you choose IP over ATM from t
Connection Type web page,
get a web page as the figure.
You may refer to Quick Start –
Connection Type – IPoA section for
more information.
Add Default Route:
Check this item to add a default IP
route.
he
you will
oA
For example, after rebooting your
router, the default route will be s
on the
Routing Table under Status
menu, you may check it.
hown
If you choose Bridging from the
Connection Type web page, you will
get a web page as the figure listed at
the right side.
Please refer to Quick Setup for more
information.
After configuring the WAN IP Setting
Next, and then you will
Check the box to enable this internet
t to disable
this setting. You may change this
setting by press the Modify icon
page, press
see the Summary page.
Check the information displayed here.
Enable this Internet Connection:
connection or uncheck i
on
the Advanced – Internet Connection
Configuration page and click Next until
the summary page is displayed.
87