Operating Instructions SWTD-1000
DYNALCO
9
//
5. Installation
The SWTD-1000 may only be installed by trained and competent personnel. An undamaged SWTD-1000,
valid configuration and suitable installation are required. Please note the Safety Instructions in Section 1.
The power to the SWTD-1000 should be capable of being disconnected via a switch or other emergency
means.
Before switching the equipment on the power supply voltage should be verified to be in the permissible
range.
The sensor cable screen must be connected to the terminal ‘Sh’ so as to minimize the influence of noise.
This terminal is directly connected internally to 0VS.
6. Connnections
6.1 Front View
The SWTD-1000 display along with the RS232 interface and the status LED are located at the front.
Communications via RS232 are described in section 8.2.
