Starting up
52
APS09_013_0404GB
When you accept the machine, you must make yourself familiar with
the equipment so that damage and accidents cannot occur.
Every time operators use the high−pressure cleaner, they accept full
responsibility for the safety of anyone located in the machine’s
danger zone. You are therefore obliged to ensure the absolute
operational safety of the equipment.
Carry out visual inspections, functional checks and a test run before
commissioning at the operating location.
Note
Any defects found during these tests must be rectified immediately.
A fresh inspection is necessary after every repair. The machine may
only be put into operation once all the inspections described below
have been concluded satisfactorily.
Each time the machine is used at a construction site, you should
check the condition of your machine and carry out a test run
including functional checks. If you identify any faults during the
checks, you must eliminate these (or have these eliminated)
immediately.
"
Always inspect the machine thoroughly for visible defects
before starting work.
"
Check the water filter for contamination.
"
Check the level in the fuel tank.
"
Check the high−pressure hose for damage.
Continuation next side
5.2
General
5.3
Checks