HIGH
LOW
Address
F
0 to A
240 to 250
F
B to F
Reserved
Table 7.1: CAN addresses
Displaying the CAN baud rate
To display the CAN baud rate, press the Recessed button and keep the button pressed down
for at least one second. Three front panel indicator lights then display the set baud rate for
two seconds. Please refer to the following table for details.
Baud rate (in kbit/s)
Audio signal
indicator light of
channel 1
Audio signal
indicator light of
channel 2
Network indicator
light
10
Off
Off
On
20
Off
On
Off
62.5
Off
On
On
125
On
Off
Off
250
On
Off
On
500
On
On
Off
Table 7.2: Displaying the CAN baud rate via indicator lights on the front panel
Configuring the CAN baud rate
The CAN baud rate can be configured using a UCC1 USB-CAN CONVERTER or directly on the
front of the device.
Changing the CAN baud rate
Notice!
The CAN baud rate can only be changed if the CAN address is set to 00.
To change the CAN baud rate, perform the following steps:
1.
Press the Recessed button and keep the button pressed down for at least one second.
The CAN baud rate is indicated for two seconds, please refer to the section entitled
“Displaying the CAN baud rate” for more information.
2.
As soon as the CAN baud rate is displayed, release the Recessed button. Please note that
if the button is pressed for more than 3 seconds, the device will be reset to factory
settings.
3.
Briefly press the Recessed button to switch to the next-higher CAN baud rate. The LEDs
indicate the new setting.
4.
Repeat step 3 until the desired baud rate has been set. (Example: To change the baud
rate from 62.5 kbit/s to 20 kbit/s, press the Recessed button exactly five times, i.e. 62.5 >
125 > 250 > 500 > 10 > 20).
5.
The new CAN baud rate is applied two seconds after the last time that the Recessed
button is pressed.
7.2
7.3
24
en | Configuration
Promatrix 6000 Amplifier
18-Jun-2015 | 04 | F01U306848
Operation manual
