PROUDLY DESIGNED, ENGINEERED, AND BUILT IN AMERICA SINCE 1969
Dynabrade, Inc.
8989 Sheridan Drive
|
Clarence, New York 14031
|
dynabrade.com
PROUDLY DESIGNED, ENGINEERED, AND BUILT IN AMERICA SINCE 1969
Dynabrade, Inc.
8989 Sheridan Drive
|
Clarence, New York 14031
|
dynabrade.com
FIGURE 28
FIGURE 29
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
NOTE:
Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
FIGURE 24
FIGURE 25
FIGURE 26
FIGURE 27
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
NOTE:
If foam sleeve
(not standard)
is installed on lid
cage, remove before installing the cartridge filter.
30. Slide the cartridge filter off
the lid cage.
FIGURE 28.
28. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise to
tighten, locking the filter into
place.
FIGURE 26.
29. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 27.
NOTE:
If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
26. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 24.
27. Place filter retainer into the
top of the cartridge filter.
FIGURE 25.
25. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
FIGURE 23
23. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection.
FIGURE 23.
24. Plug the cord into the wall outlet. Your cleaner is
ready for use.
I = ON, O = OFF
NOTE:
Many more useful tools are available at your
local dealer or Dynabrade Inc.
22. Attach the extension wands
to the accessory end of the
hose. Twist slightly to tighten
the connection.
FIGURE 23.
PAGE 8
cleaning operation.
20. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
21. Insert machine hose end with locking-nut into inlet
of tank. Turn locking nut to tighten. Do not over-tighten.
for both. When picking up large quantities of water
we recommend using a foam sleeve
(not standard)
instead of the cartridge filter. When picking up fine dust
or powders a high efficiency filter bag
must be used
with the cartridge filter.
31. Cleaning: Clean installed
filter by simply tapping or shak-
ing the vacuum unit. To restore
optimum airflow, remove filter,
tap end cap against a hard
surface to loosen debris. Ad-
ditional debris can be removed
Summary of Contents for Mini-Raptor Vac 61100
Page 14: ......
