Metal Capture Station Machine Setup
2
There is a water level window located at
the front of the machine, which indicates
the proper fill level in the “OFF” position.
Continue filling the machine until the water
is approximately ¼” short from the Water
Level Line as indicated in detail.
Do not allow the water to fill higher than
this line. If level is greater than height of
the Water Level Line, proceed to remove
water from machine until desired height is
reached as indicated.
Once the desired level has been reached,
remove hose from tank and place your
work surface into position.
Note: The machines auto-fill system will
bring the water level up to exact run height
after the machines disconnect is turned to
the “On” position as described in Step 7 of
the Machine Setup.
The machine is equipped with a self-filling
water level system, which requires a
constant water supply. The machine comes
with a ¾” female garden hose swivel
connect located at the rear of the machine
or you can remove the brass garden hose
swivel connect and use the ¼” NPT female
bulkhead fitting for providing a water
source.
3
4