Metal Capture Station Trouble Shooting
9
Ready to Start:
After plugging your machine in, proceed to move the
lockout disconnect lever to the on position, providing
power to the machine and sensory controls. Once
power has been provided, the green pilot light will start a
flashing sequence for a 25 second setup stage. Be
aware, you will not be able to power up the machine
during this flashing stage. Once the green pilot light
illuminates solid, you can then power up the machine.
*Note: Clean sensors are critical for the proper
operation of this machines auto-fill system. Be sure
to monitor and wash down sensors as required.
Refer to Maintenance section for proper machine
care.
The red pilot light is used to signal different fault
messages, depending upon its flash pattern.
A) Solid illumination:
Indicates that the water level is not sufficient for the
Start-up of the machine. With proper water source
connected, the machine will auto-fill to the correct
sensory height. Once sensor is met, the solid red pilot
light will dismiss and the green pilot light will illuminate
solid, indicating it is back to the Ready to Start mode
as indicated above.
B) Flash Pattern 1:
“ON” 4 seconds, “Off” 1 second:
During the above Ready to Start mode, the machine
will allow the solenoid valve to open and fill the machine
for a maximum of 10-minutes. If the Ready to Start
sensor is not met in this 10-minute window, the machine
will go into lockdown and will require a reset. Press the
reset button briefly until it illuminates and then release.
At this time, the machine will go back to the Ready to
Start mode as indicated above.
B) Flash Pattern 2:
“ON” 1 second, “Off” 1 second:
Indicates that the machine has shut down. The water
level is not sufficient in the run mode and the auto-fill
has attempted to reach proper water level but has failed.
The machine will now require a reset. Press the reset
button briefly until it illuminates and then release. At this
time, the machine will go back to the Ready to Start
mode as indicated above.
Power
Fault
Dynabrade: 1-800-828-7333