36" Metal Capture Station
SAFETY LEGEND
64354: 460 VAC 3 PHASE
Models:
SAVE THIS DOCUMENT, EDUCATE ALL PERSONNEL
64350: 230 VAC 3 PHASE
64300: 230 VAC 3 PHASE
64304: 460 VAC 3 PHASE
Parts Page Reorder No. PD.11.14
Effective March 2011
Read and understand tool manual before
operator, visitors and tool.
work starts to reduce risk of injury to
Practice safety requirements. Work alert.
have proper attire and do not operate tools under
the influence of alcohol or drugs
Ear protection to be worn when exposure to sound,
Local statues, ordinances and/or regulations
eye protection to conform to ANSI Z87.1
Eye protection must be worn at all times,
exceeds the limits of applicable Federal, State or
Electric shock hazard. Avoid bodily contact with
grounded objects, bodies of water.
Do not damage cord set.
limit values required by law
contaminants that exceed the applicable threshold
Respiratory protection to be used when exposed to
When operating this equipment, basic precautions should always be strictly followed
including the instructions listed below:
of electric shock with an ungrounded power supply.
2. Don't expose to rain or wet conditions. There is an increased risk
of electric shock if the switch, cord or motor are wet.
3. Do not abuse the power cord. Never use the cord to move the
station. Never use the cord to pull the plug out of the outlet. A
damaged cord increases the risk of electric shock.
4. Do not block more than 25% of work surface inlet holes
1. Always use a grounded power supply. There is an increased risk
METAL CAPTURE STATION SAFETY INSTRUCTIONS
5. Use caution when opening or closing guards, screens, etc. Switch
power off and unplug cord before opening. Remove all work
pieces and tools before opening to avoid injury. Keep fingers and
hands clear when closing to avoid injury
6. Never use to exhaust chemical vapors
7. Vibration may occur if unit is not level.
8. Unplug power cord when accessing blower compartment area
9. Power lockout disconnect switch must be off when servicing station
18
36
46
45