11
Dymax BlueWave® LED DX-1000 VisiCure® User Guide
Back Panel
The Back Panel (Figure 5) includes these components and connection points:
■
Power Cord Receptacle
—
Connection point for the Power Cord.
■
I/O (On/Off) Switch
—
Moving the switch to the I (on) position powers up the Controller. Moving the
switch to the O (off) position cuts power to the Controller.
■
Cooling Air Intake
—
Cooling air enters the Rear Intake, which includes a replaceable Filter. NOTE: The
exhaust vents located on the side of the enclosure must not be blocked or the unit may overheat and
shutdown.
■
Footswitch Jack
—
Connection point for the Footswitch. Pressing the Footswitch starts a curing cycle. In
timed operation, pressing and releasing the Footswitch illuminates the Curing Light for the length of time
displayed in the Cycle Time Display. A second press will terminate a timed cure cycle immediately. In
manual operation, pressing and holding the Footswitch illuminates the Curing Light until the Footswitch is
released.
■
PLC Connector
—
Connection point for a user-supplied cable to connect the unit to a PLC for remote
operation. Connection is a standard 15-Pin D-Style Connector. Refer to page 19 for details on the
connections to this port.
■
Irradiator Head Cable Connector
—
Connection point for the Power Cable connecting the Controller to
the Irradiator Head.
Figure 5. Back Panel Controls and Connections
Power Cord
Receptacle
I/O Switch
(On/Off Power)
Footswitch Jack
PLC Connector
Irradiator Head
Cable Connector
