Page
17
Adjusting the Mount Bracket Resistance
2. The product is engineered to control the resistance in the Tilter Mount Bracket to suit
your display swivel of +/- 90 degrees, tilt of +/- 90 degrees and also display orientation
of +/- 360 degrees. You can easily control the amount of resistance in the Tilter Mount
Bracket to suit your display monitor.
3. If the weight of the display monitor causes the Tilter Mount Bracket to tilt, it may be
required to adjust the Tilter Mount Bracket joint to suit your display monitor tilt position
of +/- 90 degrees. This can be done by using Hex Allen Wrench 4mm
(9)
. To increase
the resistance of the Tilter Mount Bracket to secure tilt position, adjust the M5x15mm
Tension Hex Socket Cap Screw located around the Tilter Mount Bracket using the
supplied 4mm Hex Allen Wrench (
See Figure 5-2
).
4. To increase or decrease the resistance of the Pivot Joint to suit display monitor swivel,
adjust the Tension Hex Cap Screw located on the front side of the Wall Mount LCD
Arm to secure the position (
See Figure 5-3
).
5. To increase the resistance, tighten the M5x15mm Tension Hex Socket Cap Screw
using Allen Wrench 4mm
(9)
in a clockwise direction. To decrease the resistance,
loosen the M5x15mm Tension Hex Socket Cap Screw using Allen Wrench 4mm
(9)
in
a counterclockwise direction.
Figure 5-2
