Dyaco FT98A-YT41, Service Manual

Page: 70 / 90

S S e e r r v v i i c c e e M M a a n n u u a a l l
69
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE WARRANTY.
BELT/DECK LUBRICATION
First, you want to clean between the belt and deck to remove any debris that may be trapped. Use a clean, non-fraying rag, t-shirt, or light towel.
Halfway between the end of the treadmill and motor cover, shove the garment under the belt until you can grasp it on both sides of the belt. Drag the
garment the length of the entire belt 1-2 times. Remove the garment.
Do not lubricate with anything other than approved lubricant. Your treadmill comes with one tube of “Lube” and extra tubes can be ordered directly from
or your authorized dealer. You may also use a Lube-n-Walk kit that can be purchased through both aforementioned sellers.
Keeping the deck lubricated at the recommended intervals ensures the longest life possible for your treadmill. If the lubricant dries out, the friction
between the belt and deck rises and places undue stress on the drive motor, drive belt and electronic motor control board, which could result in
catastrophic failure of these expensive components. Failure to lubricate the deck at regular intervals may void the warranty.
The belt & deck come pre-lubricated and subsequent lubrication should be performed every 90 hours of use or if you notice that the deck is dry. It is
recommended that you reach between the belt and deck to verify there is lubrication present, every other month.