Dyaco FT98A-YT41, Service Manual

Page: 63 / 90

S S e e r r v v i i c c e e M M a a n n u u a a l l
62
When press “START” button to start treadmill, running
belt isn’t running and window displays “LS1” error
message after 10 seconds.
1. Controller experienced unusual shut
down; the Shut_DOWN light will be always
bright.
2. Motor wires (red, black) aren’t plugged into
controller.
3. Computer cables not connected properly.
4. Computer cables are broken or damaged.
5. Motor belt is broken.
6. Controller is broken.
7. Motor is broken.
8. Console is broken.
1. Turn off power and reset the treadmill.
2. Plug wires again.
3. Plug the wire again on controller, connector and console.
4. Replace with new wires.
5. Replace with new motor belt.
6. Replace with new controller.
7. Replace with new motor.
8. Replace with new console.
The speed of the belt doesn’t match console display. 1. Console is not calibrated. 1.Calibrate the console
The incline position doesn’t match console 1 Console is not calibrated. 1 Calibrate the console.
INCLINE ERR ,INCLINE window displays “Err”. 1 Position sensor value of incline motor is
wrong.
1 Turn off the AC switch and turn on power again.
2. Calibrate the monitor.
After pressing “START” button, the treadmill stops
immediately. 1 Controller is broken. 1 Turn off the AC switch and turn on power again.
2 Replace controller and calibrate it.
Erratic pulse display. 1. Another chest belt in use around treadmill.
2. Other magnetic field disturbance.
3. Receiver is broken. 1. Check for other chest belt use around treadmill.
2. Change the position or direction of treadmill.
3. Replace with new receiver.
After pressing “START” button, the treadmill stop
immediately. Controller was broken. Replace with new controller and calibrate it.
FAST/SLOW button of SPEED ADJUSTMENT
SWITCH can’t be used.
Speed button just can press FAST, can’t press SLOW.
Speed button just can press SLOW, can’t press FAST.
1 The connector of SPEED CABLE and
CONSOLE not connected properly.
2 The connector of SPEED CABLE and
SPEED ADJUSTMENT SWITCH
W/CABLE not connected properly.
3 The connector of SPEED CABLE or
SPEED ADJUSTMENT SWITCH/W/CABLE
is
damaged.
4. Button of SPEED ADJUSTMENT SWITCH
is broken.
5. The connector of SPEED CABLE or
SPEED ADJUSTMENT
SWITCH/W/CABLE is damaged.
6. The connector of SPEED CABLE or
SPEED ADJUSTMENT
SWITCH/W/CABLE is damaged.
1. Connect cables again.
2. Connect cables again.
3. Connect cable again.
4. Replace with new buttons.
5. Replace with new cable.
6. Replace with new cable.