- 3 -
M965555 Rev. 1.1
Figure 2
SEAL
WASHER
SEAL
WASHER
2
1
3
5
7
6
4
Figure 1
UNDER SIDE
OF MOUNTING
SURFACE
18"
(457mm)
CONNECT HOSE SPRAY and INSTALL WEIGHT
• Check that seal washers are installed in both ends of SPRAY HOSE ADAPTER
(1).
Thread SPRAY HOSE ADAPTER
(1)
onto faucet SHANK
(2)
. Tighten with adjustable wrench.
Figure 1.
• Thread HOSE END
(3)
into bottom of SPRAY HOSE ADAPTER
(1).
Tighten with adjustable wrench.
Make sure all connections are tight.
Figure 1.
• Install RUBBER BUSHING
(4)
onto SPRAY HOSE
(5)
. Install WEIGHTS
(6)
onto HOSE
(5)
using two screws
(7)
. Locate
WEIGHTS
(6)
18" from underside of mounting surface on HOSE
(5)
. Tighten SCREWS
(5)
firmly.
Figure 2.
3
MAKE WATER SUPPLY CONNECTIONS
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLIES
(1, 2)
directly to wall supplies.
Connection on fitting supplies are 3/8" (10mm) compression. Connect
left supply (Marked with a Red Stripe) to Hot and right supply
(Marked with Blue Stripe) to Cold wall supply. Use adjustable
wrench to tighten connections. Do not over tighten.
• Faucet supplies are 27-1/2" (699mm) long from faucet base.
• Note: If additional supply length is required, installer must
purchase additional parts separately.
• Important: If SUPPLY HOSES
(1, 2)
are too long, loop as
illustrated to avoid kinking.
2
RED
STRIPE
BLUE
STRIPE
1
2
COLD
HOT
