- 8 -
DXE-TB-4P with DX Engineering Verticals:
If you are installing the optional Tilt Base to a DX Engineering
DXE-30VA-1
,
DXE-40VA-1
or
DXE-40VE-1
vertical antenna, the included smaller mounting plate will be installed on the antenna
insulated channel in place of the existing (larger non-tilt) mounting plate.
For retrofits
(installing the Tilt Base after you have already assembled the
vertical antenna) follow Steps 1 through 3.
For new installations
, use Step 3. Use the smaller mounting plate instead of the
larger mounting plate. Then continue using the DX Engineering antenna
installation manual that is included with your antenna.
1. Remove the antenna from the mounting pipe. Install the Tilt Base plate on the mounting pipe
using two
DXE-SSVC-2P
Stainless Steel Clamps as shown in
Figures 1& 2
. Allow
approximately 4" to 7" space between the bottom of the Tilt Plate to the top of the optional
Radial Plate (depending on original antenna installation options - refer to your antenna
installation manual for details).
2. Remove the existing mounting plate from the insulated channel. Reference
Figure 5
.
Figure - 5
