DX Engineering DXE-OTMC-250P, Instructions Manual

Page: 3 / 20

- 2 -
There are three OMNI- TILT
™
kits and one clamp kit available:
Part Number Description
DXE-OMNITILT-1 OMNI- TILT ™ Base with hardware
DXE-OMNITILT-1P OMNI- TILT ™ Base with hardware for Trap Vertical - includes one DXE-TVA-HWK
DXE-OMNITILT-2P OMNI- TILT ™ Base with hardware for Mast Mounted Vertical includes 2 DXE-OTMC-250P Clamp Kits
DXE-OTMC-250P Double V-Clamp fits 1.25 to 2.5" OD, includes bolts
Basic Assembly
The following describes the basic assembly of the
OMNI- TILT
™
base. Fastening to a customer
supplied ground mounted pipe and antenna are described after this basic assembly.
DXE-OMNI- TILT
™ Base with Hardware Parts List
DXE-OMNITILT-1 OMNI- TILT
™ Base with Hardware
Qty
OMNI- TILT
™ Tilt Base, Front, Stainless Steel with DX logo
1
OMNI- TILT
™ Tilt Base, Rear, Stainless Steel
1
5/32” Hex Wrench, 2-1/2” long
1
5/16”-18 Hex Serrated Flange Nut, Stainless Steel
2
5/16”-18 Nyloc Hex Nut, Stainless Steel
4
5/16”-18 Hex Nut, Extra Wide, Stainless Steel
6
5/16”-18 x 1.5” long Hex Head Cap Screw, Full Thread
2
5/16-
18 x 1.5” long Set Screw, Stainless Steel, Full Thread
2
5/16” Washer, Flat, Stainless Steel
10
5/16” Washer, Split Lock, Stainless Steel
4
1. Note the front and rear plates have a variety of holes which will be explained.
The front plate has mounting holes in the sides used for the tilting
process and these holes are not located in identical positions.
Take care to position the front plate properly before starting to mount
the hardware. Refer to the drawing for reference.
2. Install the upper hardware as shown. Do not tighten the flange hex
nut or the Nyloc hex nut at this time. Use Permatex Anti-Seize (part
number PTX-81343 ) on all stainless steel parts to avoid galling.
Even good stainless steel parts will freeze up if anti-seize is not used.