DX Engineering DXE-OTMC-250P, Instructions Manual

Page: 14 / 20

- 13 -
Mounting methods for other vertical antennas to
the OMNI- TILT
™ Tilt Base
Cushcraft R-8 will require a customer supplied 1-1/2” water pipe (1.90” OD) approximately
8 feet long. The water pipe is installed on the OMNI- TILT
™
base using two DXE-OTMC-
250P clamp kits.
Hy-Gain AV-620 or AV-640 will require a customer supplied 2” water pipe (2.38” OD)
approximately 8 feet long. The water pipe is installed on the OMNI- TILT
™
base using two
DXE-OTMC-250P clamp kits.
MFJ-1796 will require a customer supplied 1-1/2” water pipe (1.90” OD) approximately 8
feet long. The water pipe is installed on the OMNI- TILT
™
base using two DXE-OTMC-
250P clamp kits.
MFJ-1798 will require a customer supplied 2” water pipe (2.38” OD) approximately 8 feet
long. The water pipe is installed on the OMNI- TILT
™
base using two DXE-OTMC-250P
clamp kits.
The above listed antennas use a clamping scheme that is common and is described below
DXE-OMNITILT-2P includes the DXE-OMNITILT-1 and
two DXE-OTMC-250P Clamp Kits
Two DXE-OTMC-250P Mounting Clamp Kits are used to mount the water pipe that will hold the
vertical antenna (see listing above) to the OMNI- TILT
™
base.
DXE-OTMC-250P (Qty 2 are required) Mounting Clamps
2 - DXE-OTMC-250P Mounting Clamps with Hardware Kits
For mounting to a 1-1/2
” to 2” Water Pipe
(Parts list and picture show 2 clamp kits)
Qty
1-
1/4” x 2-1/2” Saddle Clamp, Stainless Steel
4
5/16”-18 x 4-1/2” long Hex Head Bolt, Full Thread, Stainless Steel
4
5/16” Washer, Flat, Stainless Steel
8
5/16” Washer, Split Lock, Stainless Steel
4
5/16”-18 Hex Nut, Stainless Steel
4
1. Using the mounting clamp hardware, attach the customer supplied water pipe (as described in
the previous antenna list) to the OMNI- TILT
™
base as shown.
2. When the mounting pipe is attached to the
OMNI- TILT
™
base, the antenna is mounted to the
mounting pipe per the antenna manufacturer’s instructions.