- 4 -
Installation of Balun Assembly to Antenna Lower Section
The completed balun with balun mounting bracket assembly ise mounted to the
antenna lower section. To allow easy installation of the UNUN Bracket to the
lower base section, open the upper and lower custom studded element clamps as
shown.
Position the balun and mounting bracket so the bottom element clamp is located
between the lower element bolt and the black insulator shown below. Tighten the
element clamps to hold the assembly in place. Also tighten the Nyloc nuts that hold the studded element
clamps to the bracket.
Clamps open, Clamp Ends inserted to go around the antenna element
Tighten in place with Balun facing outward
Balun Connections
The Balun connections are attached to the antenna connection using one 7” wire
with ring terminals and one 10.5” wire with ring terminals. Connect the 7” wire
with terminals from the antenna feedpoint located on the antenna element to the
terminal on the Balun closest to the
Red "+"
on the label as shown below. Do not
over tighten the wing nuts. Hand tighten them only, do not use pliers or other tools
to over tighten the wing nuts.
Connect the 10.5" wire with ring terminals from the terminal on the Balun closest
to the
Black "▬"
on the label to the bolt holding the angle plate as shown.
Use the two
included external
tooth washers when
installing the wires
with terminals on
to the Balun as
shown.
