- 7 -
Tilt Base to Mounting Pipe
Install the Tilt Base to the 2" OD mounting pipe using the two
DXE-SSVC-2P
V-Bolt Saddle
Clamps allowing approximately 4-1/2" clearance between the bottom of the tilt base plate, to the top
of the
DXE-RADP-3
Radial Plate as shown in
Figure 3
.
Make sure the Tilt Base and DXE-RADP-3 Radial Plate are oriented correctly for the
direction you wish to tilt the antenna. See Figure 8 which shows the tilt action.
Tighten the clamps evenly so the length of the exposed threads is approximately equal. Any clamp
should be tightened evenly from side-to-side with an equal amount of thread above each nut.
Figure 3
