- 15 -
Front and Rear Panels
On/Off toggle switch Control Wire Feed Through
Three Green LEDs Power Connection
3 Position Rotary Switch
The
DC
Input used is +12 to +13.8 Vdc. A 2.1 mm power cord is supplied with unit. The wire with
the white stripes is the +12 to +13.8 Vdc.
Outer Connection is GROUND, Center Pin is +12 to +13.8 VDC.
If station power is used, it must be well filtered, +12 to +13.8 Vdc at 1 amp (fused) minimum.
Tools Required
Phillips Head Screwdriver
Wire Stripper
Small Flat Blade Screwdriver
Control Console Overall Size
Interior Connections
1. Open the unit by removing the four (two per side) Phillips head screws to remove the cover.
2. Push the end of the cable through the control wire feed
through on the rear of the unit.
3. Three wire connections for the wire are made on the
green header (G-1-2).
Terminal 3 is not used
. Loosen
each terminal screw until it is near flush with the top of
the connector block as shown to the right.
4. Strip approximately 1/4" insulation from the four
conductor wire ends.
