3
Four Square Control Console Front Panel
Figure 1
Toggle Switch to turn power on and off.
Antenna pattern directional selection switches and indicators
•
One green LED illuminates to indicate which single direction has been selected. All four
LEDs are illuminated when OMNI is selected.
•
Momentary contact push button switches below each LED select a single direction.
•
White notepad blocks for writing the direction corresponding to each switch position.
Omnidirectional
OMNI
momentary contact switch
•
When OMNI is pushed, all four antennas are selected to produce an omnidirectional
antenna pattern and all four LEDs are illuminated.
•
When pushed again, the controller will return to last selected direction.
•
While in the OMNI mode, a new direction may be selected immediately by pushing its
corresponding switch.
The omnidirectional option in the
DXE-CC-4SQR Control Console
is only functional when using
the control console with DX Engineering Transmit Four Square systems.
LED brightness
The LED brightness may be set by pushing and holding the OMNI button for several seconds.
While holding the OMNI button, all the LED’s will be illuminated and then start flashing. Release
the OMNI button. The LED’s will continue to slowly flash and display four brightness settings (1
through 4). Select the desired brightness level by pressing the corresponding red switch button.
All four LEDs will then show the selected brightness setting. Press the OMNI button again to store
the new brightness setting.
Note
: The controller stays in the omni mode while adjusting LED brightness.
