11
English
Dust suction during the
power tool operation
Dust suction allows reducing dust
concentration in the air and prevents its
accumulation at the workplace. While
operating the power tool, always use a
vacuum cleaner suitable for collecting process-
generated dust. The vacuum cleaner can be connected
to the adapter
13
.
Recommendations
on the power tool operation
Cutting depth setting (see fig. 6)
Before starting the operation, adjust cutting depth
depending on the work piece thickness. The correct
cutting depth enables to obtain a cut with accurate
edges.
•
Loosen fastening screw
20
(see fig. 6).
•
Set required cutting depth, lifting or lowering the
power tool body.
•
Tighten fastening screw
20
.
Cutting mark (see fig. 7)
Front side edge of the base plate
2
shows cutting
disc
12
position during cutting (see fig. 7).
Make trial cutting to avoid errors.
Cutting
The efficiency and the quality of cutting
operations depends on the kind of the
cutting disc, therefore proper selection
of cutting disc is extremely important
depending on the material being processed and
the type of works being performed.
• Make sure that the work piece is safely fixed.
•
Switch on the power tool before cutting disc
12
touches the work piece. Let cutting disc
12
gain
maximal rotating speed.
• Smoothly move the power tool forward without
bending or pushing.
• Never press the tool - cutting requires certain time.
Extra pressure will overload the power tool rather than
facilitate the operation.
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term
exploitation of the power tool is to keep it clean.
Regularly flush the power tool with compressed air
thought the ventilation slots
3
.
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Information about service centers,
parts diagrams and information about spare parts can
also be found under:
www.dwt-pt.com.
•
Transportation
of the power tools
Categorically not to drop any mechanical impact on
the packaging during transport.
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging.
Environmental
protection
Recycle raw materials instead of
disposing as waste.
Power tool, accessories and packaging should be
sorted for environment-friendly recycling.
The plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The manufacturer reserves the possibility to introduce changes.
