V
V
V
P
P
P
-
-
-
6
6
6
0
0
0
2
2
2
H
H
H
H
H
H
T
T
T
U
U
U
25
CHAPTER 7 REMOTE CONFIGURATIONS
7.1 Telnet Commands
You can operate and configure the Switcher via a remote terminal session using Telnet.
Follow the steps as below to log into the Switcher by means of a Telnet session:
1. Connect the Switcher to LAN port of your network with RJ-45 cable.
2. Power on both Switcher and control PC.
3. Open a terminal session (command line) on your control PC.
4. At the prompt, key in the Switcher
’s IP address as below:
TELNET [IP Address]:
192.168.0.3
5. Press
Enter
Please switch the DIP Switcher PIN 1 to UP (OFF) for LAN configuration.
7.1.1 Command List and Reboot
Once the connection with Switcher is established, the VP-602HHTU Telnet prompt
screen will appear, type
help
[Enter] to show the command list.
-
Display the command list.
VP-602HHTU> help [Enter]
-
Reboot the IP Module.
VP-602HHTU> reboot [Enter]
