V
V
V
P
P
P
-
-
-
6
6
6
0
0
0
2
2
2
H
H
H
H
H
H
T
T
T
U
U
U
16
6.2 Output Connections
- Use the HDMI cable to connect the output jack (OUT1 ~ OUT2 with HDMI interface)
on the rear panel to the input jack of the projector, video recorder, display, HD TV or
multiplexer directly.
- Or use the Cat.5e cable to connect the output RJ-45 jack (OUT1 ~ OUT2 with RJ-45
interface) on the rear panel to the LINK IN jack of the Extender. Through the Extender,
you can extend the transmission distance and over-long configuring the projector,
video recorder, display or multiplexer to your Switcher.
Figure 6-3 Output Connections
6.3 Multiple Connections
- MIC: Connected to the microphone.
- SPDIF: Uses the SPDIF cable with RCA or Toslink connector to connect the SPDIF
port on the rear panel to the AVR device. Then, transmit signals through coaxial or
fibre optic of SPDIF cable.
- R/L: Uses the R/L cable to connect the R/L output port to AMP speaker for audio
connection.
- Use the RS232 cable with 3.5mm connector to connect the RS232 1~2 port on the
rear panel to the RS-232 jack of PC.
- Use the IR Receiver and IR Blaster to connect the IR ports (RX1/RX2, TX1/TX2) on
the real panel for remote control.
The Switcher integrates the IR RX/TX and RS232 input signals and outputs the
signals via the RJ-45 port simultaneously. Through the extender, the output signals
will be transmitted to the remote device.
