V
V
V
P
P
P
-
-
-
6
6
6
0
0
0
2
2
2
H
H
H
H
H
H
T
T
T
U
U
U
23
6.7.4 Output Cable
HDBaseT was designed to provide Full HD performance up to 100/70 meters of Cat.5e
or superior cables. In a typical installation, the cable is stretched to its full length between
the HDBaseT Transmitter device and the HDBaseT Receiver device. However
sometimes, especially, in demonstrations or in a lab environment, the cable is rolled
randomly in small turns for convenience. The randomly rolled UTP cable suffers
additional signal impairments (compared to straight cable) and therefore the maximal
operating reach might be reduced. When a Cat.5e cable is randomly rolled, it is
recommended to limit its length to approximate 50 meters. Rolling a Cat.5e cable around
a 70cm fixed diameter plastic drum has just a minor effect on the FEXT (Far End Cross
Talk) when compared to a fully stretched cable.
Figure 6-11 Output LAN Cable
The VS010 family features the following:
When the VS010 is in low power mode (LPPF1/2), the sample rate of the PDIF channel
is reduced to 100 KHz. This implies that high data rates may not be used when the
VS010 is in LPPF.
Enables 10.2 Gbps of HDMI 1.4 traffic (including HDCP) over a single LAN cable
according to the following specifications:
Cable Type
Range
Supported Video
CAT5e/CAT6
60 meters
Most common full HD formats:
- Up to 1080P, 60Hz, 36bpp
- Data rates lower than 5.3 Gbps or below
225 MHz TMDS clock
CAT6a/CAT7
70 meters
CAT5e/CAT6
35 meters
Ultra HD video formats:
- Deep color: 1080P, 60Hz, 48bpp
- 4K x 2K
- Data rates higher than 5.3 Gbps or above
225MHz TMDS clock
CAT6a/CAT7
40 meters
Full HD support: 1080P@60Hz@48b/pixels, 3D, 4K x 2K
