Dvorak Spider ILD01, Service Manual

Page: 37 / 98

37 / 98 SM-1 Ev4/100901
6.19 Exchange of the wheel axis
Dismount:
-
Wheel (3 screws fixing the wheel)
- Dismount the main wheel nut (Picture 85)
- Remove the wheel hub (use wheel hub puller), spacing ring and spring
- Clean the wheel shaft (it must get through the bearings)
- Dismount the lid, tightening segment and chain (see 6.18 Adjustment and exchange of the wheel driving
chain )
- Pull the wheel shaft with the chain disc out of the bearings
- If the bearings need to be exchanged, dismount the securing ring of the bearings and press the bearings out.
Mounting:
(take reverse steps)
- Lubricate the shaft with grease.
- Degrease the cone seating of the wheel shaft and wheel hub
- Put on new spacing ring, spring, wheel hub, washer
- Check a good seating of the wheel hub to the cone of the wheel shaft
- Secure the main wheel nut with glue (Picture 85)(LOCTITE 243) and tight it. (100 Nm)
- check the gap between wheel housing and wheel hub it should be cca 1-2 mm
- mount the wheel back
Picture 85
Picture 87
Picture 86
Picture 88
Gap 1-2 mm
Securing the bearings