-6-
Transmitter Unit Rear View
1
12 VDC Power Input:
screw locking female connector for AC Power Adapter.
2
HDBaseT Output:
RJ-45 female connector.
See warning below.
3
IR IN:
connect IR receiver to send IR signal over CAT-X cable to Rx Unit.
4
IR OUT:
connect IR transmitter to accept IR signal from Rx Unit and
output to a source device.
5
RS-232:
3-pin female Phoenix Connector for serial data pass-through.
6
HDMI Input:
female connector; connect to an HDMI or DVI source.
7
Ethernet:
RJ-45 female connector (only on DVI-7525).
8
Service Switch:
reserved for qualified technical personnel
Receiver Unit Rear View
1
12 VDC Power Input:
screw locking female connector for AC Power Adapter.
2
HDBaseT Input:
RJ-45 female connector.
See warning below.
3
IR IN:
connect IR receiver to send IR signal over CAT-X cable to Tx Unit.
4
IR OUT:
connect IR transmitter to accept IR signal from Tx Unit and
output to display device.
5
RS-232:
3-pin female Phoenix Connector for serial data pass-through.
6
HDMI Output:
female connector; connect to an HDMI or DVI display.
7
Ethernet:
RJ-45 female connector (only on DVI-7525).
8
Service Switch:
reserved for qualified technical personnel.
WARNING:
The HDBaseT ports are designed to connect to compatible DVIGear products only.
Do not connect any device to the HDBaseT connector unless you are sure it is compatible.
Connecting incompatible devices with similar connectors may cause harm to the devices.
It is typical for HDBaseT receiver units to operate at higher temperatures than transmitter
units. In order to ensure proper operation and long term reliability, care must be taken to
ensure airflow is not restricted in any way.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
