Each transmitter and receiver unit comes with a pair of mounting brackets to
facilitate installation on furniture or other surfaces. These mounting brackets are
reversible, so the unit may be installed above or below the mounting surface. To
affix each bracket to an extender unit, place the side of the bracket with the large
rectangular ventilation opening against the side of the unit. Next, use the supplied
screws to secure the bracket to the two mounting holes located on the each side
of the extender units. These mounting brackets may also be used to attach the
extender units to the optional rack mount kit (DVIGear p.n. DVI-7520-RMK).
To do this, first attach the mounting brackets to the units using the instructions
above. Next, place the units into the desired location on the DVI-7520-RMK.
Note that there are three (3) locations available: Front, Middle, and Rear. Two
units may be mounted side-by-side and either forward-facing or rear-facing.
Finally, use the screws, washers, and nuts included with the DVI-7520-RMK to
secure the units to the rack mount kit. See the drawing below.
Rear Mounting Location
Front Mounting Location
-10-
