8
Assembled Cable Bundle Ready for Pulling
17.
To pull the cable bundle through the conduit, tie a suitable cord through the Pull Loop on
the sleeve. Then, from the other side of the conduit, gently pull the cord. If resistance is
encountered, gradually increase the pulling force. If the cable bundle will not move with
moderate pulling force, STOP pulling and pull the cable back from the other side. Please
examine the fill in the conduit and remove any obstructions, then try pulling the cable bundle
again. Cable lubricant may also be used to assist with pulling, and is recommended for
difficult cable runs.
NOTE:
NECA standards for cable runs specify that conduit should be not more than 40% full,
and should have not more than two 90 degree bends per pull. The performance of this Pull
Sleeve Kit may be degraded if these standards are exceeded.
18.
Once the cable bundle has been pulled, inspect the Pull Sleeve for any signs or damage. If
there are signs of damage on the sleeve, note the location and inspect further in this area
once the Pull Sleeve has been disassembled.
19.
To disassemble the assembled Pull Sleeve, follow the assembly instructions above in
reverse.
NOTE
: The use of knives for disassembly is NOT recommended, as they may damage the cables
in the bundle.
DVIGear
1059 Triad Court, Suite 8
Marietta, GA USA 30062
Toll Free:
888.463.9927
Tel: +1.770.421.6699
Fax: +1.770.234.4207
[email protected]
www.dvigear.com
DVI-2600-AOC-PSK-QSG-02 / August.2020
© 2020 DVIGear, Inc.
DVIGear, Inc. is the owner of numerous trademarks, both registered and unregistered,
including without limitation, the following marks: DVIGEAR
®
, DISPLAYNET
®
,
DISPLAYNET SERVER
®
, DISPLAYNET MANAGER
®
, N/AV Design
®
, and HYPERLIGHT
®
.
All other third party trademarks used herein are the properties of their respective owners.
